update on my car

[Dan Simoes <dans@ans.net>]

Yes, I still have it :)
I finally got the tranny out, because I noticed that behind
the throwout bearing there is a sleeve held in by 3 screws.
One was missing (at the bottom of the case) one was loose,
and one was OK.  So now the tranny is sitting on my gravel 
driveway (can't get the car up high enough to clear the
tranny) and I'm wondering what else to do before I attempt
to put it back.  Bentley talks about greasing a few areas with
MoS2 grease, whatever that is.  I *have* to get this car done
soon!  I'm ordering new seals for the axles and inner CVJ boots
on Monday, put in new O2 sensor (needed it), and might need
to replace the diff cable (it's frayed I think).  Anything else?
I *will not* be going back into this tranny again.  Promise!
Oh yeah, the clutch stuff was done when we replaced the engine 
a couple of months ago...

| Dan |
-- 
Dan Simoes			          dans@ans.net
ANS 				http://coimbra.ans.net/dans.html
100 Clearbrook Road  			(914) 789-5378 (voice)
Elmsford, NY 10523			(914) 789-5310 (fax)