Re: Can't bleed the clutch...Please Help.

[PDQSHIP@aol.com]

In a message dated 96-10-24 16:06:54 EDT, you write:

<< plate and throw out bearing too.  I made sure that the fork was aligned 
 with the slave cylinder piston when the trans was put back up into place. 
  The clutch system had worked before my repair.  Now that the system is 
 back together I have tried bleeding the clutch system, but I still can't 
 get the slave cylinder to engage.  As far as I can tell, the master 
 cylinder is working.  I assume this is true  because when bleeding the 
 system and pressing the clutch pedal I get a pressurized stream of fluid 
 from the bleeder valve.  One thing to note is that I did let the system 
 drian out after disconnecting the hydraulic line.  
 
 Is t >>
Prolly jammed the slave....... Pull  the slave out of trans (can be done with
trans in car.....  make sure it is functioning properly.....  reinstall
 (make sure that the pin didn't like fall ala dan s.) and try again...

Scott