Re: A4 Rain guard screw?

[Jay@aol.com]

In a message dated 96-11-06 21:51:08 EST, drobbins@net2net.com (David
Robbins) writes:

> >In installing this #(*$ stereo, I removed a screw/bolt from the plastic
rain
>  >guard under the hood on the passenger side, right below the windshield. 

>  
>  If I understood what you're looking at, it's the piece of plastic that
runs
>  the entire length of the windshield...  If so, it is held in place by four
>  screws that have large, round and flat heads.  They look like they could
be
>  unscrewed with a quarter.  Also on the passenger side, away from the
>  windshield is a single screw/bolt that requires a ratchet (maybe 1/4 inch
>  hex?).  Hope this helps...
>  

Right, it's that single screw/bolt I'm trying to figure out.  The regular
ones are not fitting into the hole.. or actually they are, at the tip (which
is tapered), but they aren't grabbing.  Anyone feel like removing theirs to
see what it is?  I'll give you a free AOL disk!  :)

Jay