[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: Crank Bolt socket = 27MM
In a message dated 97-02-16 23:54:12 EST, you write:
<< > THAT PART IS A 27MM SOCKET, SEARS AVAILABLE, Do not use the 1 1/16, the
> torque you put on that bolt is VERY high, like in the 300ft/lb range, not
> good for fudging sizes..... It's close in a 1 1/16, but hardly where you
Betcha you couldn't tell the difference without looking at what was
stamped on the side. 1.0625 vs 1.0630". Less than 1 1/1000t of an inch.
I wouldn't worry about it myself... don't remember what I used, I'd
have to look in the toolbox ;-).
Orin.
>>
Sure, me, I'd want a 26 if it was possible, this is serious torque, in fact,
there is NO higher torque setting on a q than that 1 bolt..... .0001 is
prolly within manufacturers tolerance, and I would argue the 6 point thing
before the 12, but man, this is a critical life support operation here... I
bit the bullet and just bought the proper audi tool..... Not sure it's a
mute, cuz few have that torque wrench available anyhow (the cheapest I found
it was 300USD).... Don't forget the loctite either..... I can share that I
have tightened at least 3 of these bolts that were incorrectly installed...
Beware of your actions here, they are critical...
Scott