RE: Wheel rattle/Indicator Stalk R/R

["Stefan Bendevis" <Audiman1@msn.com>]

----------
From: 	owner-quattro@coimbra.ans.net on behalf of Allan Jones
Sent: 	Monday, February 17, 1997 10:39 PM
To: 	quattro@coimbra.ans.net; Bruce G Plante
Subject: 	Re: Wheel rattle/Indicator Stalk R/R

Bruce G Plante wrote:
> I have a 87 5kSQ with 150k.  I am back with several problems I need advise 
on.
> 
> 1)Combination switch(turn signal) will not go out of high beam.  Recommended
> vendor quoted $150 for new. Curious if there are any out there for cheaper,
> any other suggestions (currently using rubber band attached to the light
> switch), and if this a job for a do it your selfer.

<<    I'm presently staring at the indicator stalk and have no idea how to
remove it w/o breaking the SOB. Know you let me know it's $150! I was
going to try force, but not for $150! Somebody, please help. I removed 3
screws out of the metal contact plate after the steering wheel came off
and do not know what to do next. Like I stated in previous post, the
switch circles around the steering wheel spindle and I can get the
plastic circle to move 15-20 degrees away from the plane perpendicular
to the steering shaft, but nothing else. Is it conected to a set of
wires that don't want to let go or is there a screw(s)?
				THANKS TO ALL IN ADVANCE,
							   Allan>>
	If you look in the bottom of the plastic housing for the combo switch you 
will see a hole.  This hole provides access to a screw, you will have to put 
your philips screwdriver in this hole pointing towards the shaft and loosen 
it,  the combo switch is clamped around the spindle (you might have to move 
the screwdriver around a bit before you find the screw).  Once you do this, 
the whole assembly should slide right off the spindle.

	Good luck, Audiman1@msn.com, Stefan Bendevis