[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Source for Parts/Tools
In message <199702182103.AA27122@igw.fmc.com> christopher_bender@fmc.com (CHRISTOPHER BENDER) writes:
> Snap-On has those 12 point drivers in all of the right sizes. First
> quality tool. Go for it.
> Also, where is a good place to buy the 12 point driver that is needed to remove
> the axle flange from the transaxel and differential? I think it is 8mm.
Snap-On have the 10mm tool as STSM10B. They have two 12mm, STSM12A and
STSM12LA - the former is 109.5mm and the latter 147.6mm in length. All are
1/2" drive.
My 12mm was made by Draper and is 97mm in length. It's almost _too_ long for
the "replace head gasket without removing manifolds" trick because it fouls the
inlet manifold when used on the back head bolts on the manifold side - you
have to worm a universal joint in there. And it has to be one that will take
60Nm plus 2 x 90 degree turns. I use a King Dick.
Snap-On list the 8mm tool as FTSM8C in 3/8" drive. There's a long version
(84.6mm versus 58mm) as FTSM8AL - but there may be a catalogue error (page 73)
because it has "6mm" against it in the table, even though the code seems to
suggest it's 8mm. Caveat emptor.
--
Phil Payne
phil@sievers.com
Committee Member, UK Audi [ur-]quattro Owners Club