[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: Brake Bleeder Adaptor (was Brake fluid replacement)
In a message dated 97-02-20 23:11:53 EST, you write:
<< >Can you tell me the source/ P/N for the metal cap?
The company is AST. The adaptor is stamped "TA 18", that may be the
P/N. It comes sans quick-conect plug, threaded 1/4 NPT. SnapOn bleeders
require "T" style, others are different. Any auto parts store should be
able to fix you up if you bring in the bleeder.
I got mine adaptor by flagging down a Mac truck. AST has their own
catalog. Two SnapOn dealers I talked to didn't know anything about this
company, but SnapOn's (800) folks can get it, if you tell them "AST" and
"41 mm dia".
>>
Snap-On has the medal cap available, but it doesn't include the "special"
(read non standard) fitting to the bleeder.... It seems the shank dia is
slightly smaller.... Until mine arrived, I ground down a 1/4 NPT quick
disconnect to work... The Snap-On parts are as follows:
* BB100A Pressure Brake Bleeder - ~150. USD
* YA8925 Master Cylinder Pressure Cap (audi, Bmw, vw) - ~30. USD
* BB400-47 Quick Disconnect Male fitting - ~ 6. USD
After doing the manual Clutch MC bleed last week, the above loaned PN's were
missed greatly
HTH
Scott