Re: CIS gauge

[Sdbigelow@aol.com]

In a message dated 97-03-10 22:40:19 EST, you write:

<< 
 ..>From:  (Phil Payne)
 ..>Date: Mon, 10 Mar 1997 21:52:07 GMT
 ..>
 ..>I found what was causing my "hot full load" stumble - the plug wire to #3
was 
 ..>not connected to the cap!
 ..> Does the logic appeal?  Is my next step to verify static timing?
 
 can't see how advancing the timing would produce this problem, as the
duration of the spark (ie, the length of time available for the coil to
produce the necessary voltage) stays the same, regardless of the amount of
static advance dialed in....
 
 or am i missing something myself?
 
 - -dave
 '>>

Well, you both might be missing cylinder pressure issues. I'll assume Phil,
being a gentleman, did not apply any  _cold_ full load. Soooo, it only
stumbles at full load.
Fine. Two gaps to jump with highest possible cylinder pressures. 
Cough, stutter.

Toodles

Steve Bigelow
Bigelow & Pauly Masonry. Current Project: Parliament Hill, Ottawa Canada
84 5ks