[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

MAC-10 connector wires



In message <9703178613.AA861321622@smtplink.exabyte.com> piotr@Exabyte.COM writes:

>      I just started looking closely at my MAC-10 unit connector and noticed 
>      2 wires which appear to have been cut/disconnected.

a) Consider your ASCII art stolen.
 
b) I'm conducting a project to document the MB engine (MAC-12) in the absence
   of comprehensive documentation from Audi.  This is as far as I've got with
   the ECU part of the wiring harness:


 
Audi quattro - MB engine (MAC-12) ECU wiring

The  ECU is connected to the wiring harness via a  latch-
and-swing  connector.   With the  ECU  removed  from  the
vehicle,  the wiring harness connector should  be  viewed
with  the  plastic prongs on the right and  the  locating
lugs  along  the side of the connector at the  top.   The
upper  left pin is Pin 1, with numbering proceeding along
the connector to Pin 18 at the top right.  The bottom row
is  also numbered from left to right, from Pin 19 to  Pin
35.

1.        Blue/White         Cold Start Valve (N17)
2.        Brown/Yellow       Chassis
3.
4.
5.        Brown/Yellow       Chassis
6.
7.        Mauve              Idle  Stabiliser (J142), Oil
                             Pressure Warning Controller
8.        Blue/Black         Frequency  valve  (N7), T35/3
9.        Brown/Red          Chassis
10.       Blue               Coolant Temperature (G62 - side
                             of block)
11.       Blue               Engine RPM Sensor (G28)
12.       Mauve              Ignition Timing Sensor (G4)
13.       Red                Ignition Timing Sensor (G4)
14.       Blue/White         Electronic Thermoswitch (F76)
15.       Brown              Knock Sensor (G61)
16.       White              Knock Sensor (G61)
          Brown              (shield for above)
17.
18.       Brown/Yellow       Chassis
19.       Green/Yellow       Wastegate Control Valve (N75)
20.       Grey               Idle Switch (F60), Idle
                             Stabiliser (J142)
21.       Brown/Red          Fuel Pump Relay (J17)
22.       Green/White        Electronic   Ignition
                             Power Stage (N70)
23.       Brown              Inlet Air Temperature Sensor (G42)
          Brown/Red          Hall Sensor (G40)
24.       Blue               Hall Sensor (G40)
25.       Red/Black          Hall Sensor (G40)
26.       White              Full Load Switch (F81)
27.       Green              Hall Sensor (G40)
28.       Brown              Shielding for 11, 12, 13, 29
29.       Grey               Engine RPM Sensor (G28)
30.
31.       Black/White
32.
33.
34.       Brown/Yellow       Chassis
35.       Black/Red          Power via Fuse (S34, 10A)


--
 Phil Payne
 phil@sievers.com
 Committee Member, UK Audi [ur-]quattro Owners Club