QLCC Overshoot, Stock WG spring

[scott.john.mockry@bangate1.TEK.COM]

Steve Buchholz,

If I remember correctly, the guy (who was that masked man?) 
who sent you that used MAC11 ECU with the  modified EPROM 
chip, installed the chip that ONLY had the overboost fuel pump
cutoff raised to 1.95. In other words the boost map was NOT
modified. 

I think you were also sent an additional chip that
was marked Mac11C4 that DOES have the boost map
tweaked to provide about 1.8 bar. If you installed that
MAC11C4 chip and still don't get above 1.4 bar then
either your full throttle switch is kaput, or some other
system component is not functioning (knock sensor,
Waste gate solenoid, vacuum hoses etc) You may
want to check for any fault codes as others have suggested.

If you don't have the MAC11C4 chip then let me know..........

HTH
Scott M.