Re[2]: Further question on vacuum pump

[KSMITH1@mailgw.sanders.lockheed.com]

The pump mounting flange bolts to the side of the head with an o-ring 
for a seal.  No method of moving it closer is evident.  Perhaps within 
the vacuum-generating part of the pump (that I didn't try to 
disassemble) there is an adjustment that would somewhat lengthen the 
hexagonal shaft. 

***                 ...Kirby    (Kirby A. Smith)                 ***
***                      2 X 1988 90q                            ***
***              ksmith1@mailgw.sanders.lockheed.com             ***
***              [=]   kirby.a.smith@lmco.com                    ***
***  Opinions expressed herein are entirely those of the author. ***




______________________________ Reply Separator _________________________________
Subject: Re: Further question on vacuum pump
Author:  chris@maximum-bhp.u-net.com at INTERNET
Date:    5/27/97 9:59 PM


Is it not feasible to move the pump,and hence rod,nearer the lobe,and 
preclude any clearance altogether?


-- 
    Best Regards,
                 Chris Wilson
http://www.maximum-bhp.u-net.com
mailto:chris@maximum-bhp.u-net.com