Re: removing large suspension bushings without a press (generic content)

[WARATAP@aol.com]

In a message dated 97-05-28 03:00:56 EDT, posne@cts.com (mike posner) writes:

<< That my Schley super wheel bearing puller would not work
 as the diameter of the puller is way too big. Trying to hammer it out is
 out of the question- from the heft of the bushing and that of the thick
 steel bracket,it would seem to require a 15 to 25 ton press to get the job
 done. Anyhow ,if anyone has any ideas
 before I throw in the $300 towel, tia.  Mike Posner >>

Maybe 12 tons would suffice?  JC Witney has a 12 ton hydraulic press for $150
+ 10% off for new customer discount 'til May 31st, but for obvious reasons it
has to be shipped via trucking co.  Ph#312/431-6102

-Ingo