1983 UrQ parts fiche question

[quk@sievers.com (Phil Payne)]

In message <199707091725.NAA00287@ns.tamsconsultants.com> afinney@tamsconsultants.com writes:

> Two different parts, two different questions. Injector inserts.
> Two are pictured on the fiche. My old ones are the short
> stubby ones pictured. The longer ones have a slightly smaller
> diameter and require 12mm allen to remove, mine require
> 13mm to remove. I assume the short ones are the correct
> replacement? Are there seals for these inserts? Question 2:
> Ball joint to A-arm mounting bolts. Mine used a lock plate
> and bolts. The fiche shows lockplate and studs with two
> different stud lengths. I assume the longer length is correct
> for the UrQ? Does it matter that they're studs and not bolts?
> Any help is greatly appreciated. If there is a cutoff my VIN
> ends with DA900543. Phil, you're always mucho helpful on
> the parts info. Thanks a lot.

This will have to wait until tomorrow evening - I have a long trip tomorrow and 
I've just packed everything into the car, including the fiche and the toolkits.
 
You have 13mm inserts in a _1983_ car?  Do you have the forced air feed around 
the injectors?





--
 Phil Payne
 phil@sievers.com
 Committee Member, UK Audi [ur-]quattro Owners Club