A\C problem

[julio <elprofe@mail.isla.net>]

The "Basic Setting" on Audis it's VERY IMPORTANT.All ECM(Engine Control
Module,Air Bag,A\T Control Module,A\C Control Module etc)Use in any form
the input an output from the VAG 1551/2 scan tool to perform the process
that could call "learning adaptation".When uses the VAG 1551/2 in this
case on A\C control unit the scan tool moves all flapper to "adapt" the
original position between the higther point to a minimun point, taken a
position in relation to each other(sound a little complicat).The problem
is that the scan tool are very expensive if you only work with your car
only,but in a long way it pay itself(only if you stay w\Audi)