Re: Light removal

[fred smith <smitty@pcrealm.net>]

Nivi@aol.com wrote:
> 
> Hi Smitty,
> 
> In a message dated 97-09-14 18:27:09 EDT, you write:
> 
> <<  Nivi,Open the hood,the trim below the headlight (body color) has a single
> 
>  screw on the end next to the radiator.>>
> 
> Found the single screw originally...the trim piece was quite secure on the
> outside of the car (near the turn signals), I just want to make sure I don't
> damage anything...in what direction should I pull? (after the washer nozzle
> removal)
>

Pull toward the radiator (or center of the car).  passenger side ----->
                                                  <----- driver side 


 The hose that is attached to the rear of the pressure cylinder.Clamp it so you don't   
         loose the fluid.(could be black or clear,have seen both,any way,it attaches
           to the back of the cylinder by a hose clamp.
> <<Remove the spray jet assy.>>
> 
> Just pull?? Rotate? TIA...

    that's it,just pull,turn,wiggle 'till it comes out of the pipe.>
 

   By the way the screws that hold the light assy in place are the front 2 screws,
    the rear ones are for adjusting.


Smitty