[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: speedo
On Thu, 23 Oct 1997 12:50:42 -0400 (EDT) "Shane Allen Snyder"
<snyders2@pilot.msu.edu> writes:
>Hello Again,
>
>I have not get attained a Bently guide for my '86 4kcsq. Could
>someone please
>explain to me how to remove the speedo...?
>
>Thanks!!!
>
pull horn button off (you'll probably break at least on of the little
buttons that
it clips to. pull it off evenly on both sides.
Remove steering wheel 24 mm nut
remove two screws that go into dash above gauges
pull cluster out
If mechanical speedo, be careful of cable. push in on retainer and
"unscrew"
remove all wires from back of cluster Don't worry. All connectors are
specific. You can't mess them up putting it back.
Take cluster to work area.
Lay it on its face and remove screws around perimeter so white plastic
molding can be removed
The speedo is held to this backer with several small hex head screws.
Also remove wires for cruise control if it has them
If mechanical, reset OXS timer while you have it out.
email me direct at address below if you have any problems.
Paul Anderson, Cheyenne, WY 87 5000SQ, 84 5000CST,
email: 82 VW Quantum, 78
Fiat Spider
AndersonPaul@juno.com 87 Merkur XR4Ti
My wife loves her new Blizzaks on the XR4Ti!!!!!!
All vehicles owner maintained and serviced.
- References:
- speedo
- From: "Shane Allen Snyder" <snyders2@pilot.msu.edu>