MAC 11B ECU

[quk@isham-research.demon.co.uk (Phil Payne)]

In message <E0xj0Q0-0003Jy-00@iglou.com> "Douglas Hurst Quebbeman" writes:

> My fuel pump relay has the molding in the plastic relay cover to
> accept a fuse (which we use to initiate the code dumping sequence)
> but when I removed the cover to find out why the fuse didn't want
> to seat properly, I found that there were no electrical contacts 
> inside the relay that connect to the fuse's contact blades! On the
> relay's small printed circuit boards, the were places for the 
> contacts to be soldere onto the board, but had never been installed.

I've seen one of these things - it's also a little smaller than the 'official' 
component.

-- 
 Phil Payne
 Committee Member, UK Audi [ur-]quattro Owners Club