[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: Fault code 2113, what is it
Thanks Phil,
I will do my best not to say too many nasty things about you......be
patient, it won't happen in one day...
joke joke joke......
Thanks again,
Avi
At 08:05 AM 12/27/97 GMT, you wrote:
>In message <3.0.4.32.19971226170606.0069a198@mailer.cosmoslink.net> Avi
writes:
>
>> I am looking for information about fault code 2113, what is it?
>> Can't seem to find it in the Bentley, must have missed it, although i
>> looked a number of times....
>
>
>Code Source Possible cause Check
>
>1111 Control Unit Defective processor Replace unit
>
>2111 RPM sender Open or short circuit,
> defective sensor Sensor & cables
>
>2112 Timing sender As RPM, or flywheel
> peg mislocated Sensor &
> flywheel peg
>
>2113 Hall sender As RPM, or distributor
> mislocated Sensor &
> distributor
>
>2121 Idle switch As RPM, or switch stuck
> in position Switch and cabling
>
>2123 Full load switch As idle switch As above
>
>2141 Knock regulator Fuel octane too low Compression,
> injection, boost
>
>2142 Knock sensor Open or short circuit,
> defective sensor Sensor and cabling
>
>2221 Vacuum hose Vacuum hose to
> controller defective Check hose
>
>2222 Pressure sensor Control unit's pressure
> sensor defective Replace unit
>
>2312 Coolant sensor Open or short circuit,
> defective sensor Sensor and cables
>
>2322 Inlet air temp. As above As above
>
>2214 Over-revved Engine has exceeded
> rev limit Driver
>2224 Excess boost Wastegate or pressure
> tubing Wastegate and
> plumbing
>
>
>
>--
> Phil Payne
> Committee Member, UK Audi [ur-]quattro Owners Club
>
>