Re: Driveshaft removal

[harrison <hsapir@multiverse.com>]

You must unbolt the arm because the shaft sits in a cup in the center of the flange.

harrison

Sachelle Babbar wrote:

> I wanted to know if I can remove the driveshafts on my car by removing the
> inner cvj bolts and sliding up, removing outer bolt, sliding out. I wanted
> to know, because the last few times they were done on any of my Audis the
> lower control arm was unbolted, too. It would make my job a lot easier if
> I could do it without disconnecting any of the suspension pieces. Any
> btdts?
>
> **************************************************************************************************************************************************
> *Steve                                       Sachelle Babbar
> *'84  5ksT 1.6-2.0 bar                    <SBABBAR@IRIS.NYIT.EDU>
> *Cockpit adjustable wastegate, AudiSport badge
> *
> *Disclaimer:"Any information contained herein is based purely on my own
> *personal experience and may not necessarily reflect yours. Use caution as
> *your results may vary from mine."
> ********************************************************************************