Re: ur-quattro clutch slave cylinder

[Dave Eaton <dave.eaton@minedu.govt.nz>]

further investigation reveals that the later ur-quattros ('ja' onwards ie. mb,
rr) have done away with the spring and pin and replaced with a simple bolt. 
the slave cylinder is also different.  i will extract same on the weekend...

dave
'95 rs2
'90 ur-q
>In message <3432251123041998/A97404/CSAV05/11C4BAD91F00*@MHS> Dave Eaton
writes:
>
>> also, does normal bleeding practice apply here?
>
>The only thing I've found critical in bleeding is making sure that the
>piston in the master cylinder _completely_ sweeps the bore.  This is
>because the master cylinder is mounted at around a 30 degree angle
>and air bubbles within the cylinder do not naturally return up the
>feed pipe.
>
>--
> Phil Payne
> Phone: 0385 302803   Fax: 01536 723021
> (The contents of this post will _NOT_ appear in the UK Newsletter.)