Re: Stainless oil cooler hose

[Elliott Potter <epotter@abraxis.com>]

Smith, Kirby A wrote:
> 
> "Gary G. Erickson" <erickson@teleport.com> wrote:
> [...]
> >What about using some of the larger diameter heat shrink tubing?
> >Reasonably robust, and would seal well enough to keep quite a bit of
> >crud and grit out of there.
> 
> Ideally, this would be silicone rubber shrink tubing, which is highly
> flexible.  Unfortunately, I've lost track of the source of this stuff,
> but it sure was flexible.

I haven't seen silicone heatshrink tubing, but what about Polyolefin
heatshrink tubing?  It's pretty flexible...

-- 
Elliott

Where am I going, and why am I in this handbasket?
	--Seen on a bumper sticker

Christos Anesti!