[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: 89 octane OK in 2.8L V6?



I've got a 1993 90S (fwd only, sigh!) with the 2.8 V6 and I usually run
Premium (92 octane), occasionally I'll run a tank of Super (90 octane),
but that is the minimum I'll use. These are high compression engines and
I believe that performance will suffer with anything less, not to mention
the possibility of extra carbon build up from incomplete burn in the
cylinder.


BOEING377@aol.com wrote:

> The manual says use only high octane gas (92 or higher).  I tried 89 and no
> knocking was detectable.  Am I getting less power or hurting fuel economy?  Is
> the knock sensor retarding the timing or does the car run fine on this lower
> octane?  I don't do hard acceleration normally, but even when I did I couldn't
> detect any knock or loss of power with a tank of 89 compared to perfornmace
> with 92 octane.  Comments?  Mark,  92 100S 86K



--
Todd Young              WAM!NET Inc.
tyoung@wamnet.com       6100 West 110th Street
612-886-5051            Bloomington, MN 55438-2664
800-585-1133 ext.5051   http://www.wamnet.com/