Torques

[quk@isham-research.demon.co.uk (Phil Payne)]

Catching up - three requests:

a) Centre bolt on rear differential (Flanschwelle an Achsantrieb)
   is 10Nm + 90 degrees.  The drive shaft bolts are 45Nm if M8
   and 80Nm if M10.

b) All differential cover plates seem to be 25Nm.

c) The hub nuts are 280Nm.  The splines should be free of oil and
   grease, and a 5mm wide smear of D6 locking paste should be
   applied to the end of the splines that enter the hub and left
   to harden for 60 minutes.  _ALWAYS_ use new hub nuts.

--
 Phil Payne
 Phone: 0385 302803   Fax: 01536 723021
 (The contents of this post will _NOT_ appear in the UK Newsletter.)