[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: Project 4ktq started


Uh Oh Phil,
	This is new to me.  With the engine End Mounted does it fles
enough to warp the bores slightly?  That is interesting.  Any other
tidbits of advice before I tear into it?  Does it matter on this engine
exactly where I mount it on the stand.  I will check the bently if it
mentions it but if not, just any three holes oposing each other?  Bolt it
through or can I use the threaded holes that are cast into it?  Again,
this not matter.  THanks for the warning

	Todd

> 
> Don't forget the classic I5 advice about not measuring the bores with
> the engine end-mounted on a stand.
> 
> --
>  Phil Payne
>  Phone: 0385 302803   Fax: 01536 723021
>  (The contents of this post will _NOT_ appear in the UK Newsletter.)
>