rear window defroster

[Mike Mulholland <meyeke@netinc.ca>]

silver based solder requires a HIGHER temp than standard solder. the higher
the tin content the lower the melt point. the advantage of silver content
solder is a much higher mechanical strength than regular solder...so it
would be ideal for wot switches and such. if you dare to attempt to resolder
your connection on the window..clean the joints as well as possible, flux
the joint and preheat your 45w iron until it melts the solder at a touch.
tin it with solder and make your joint with an rapid touch of the prepped
iron. this should make a good joint. if you're not familiar with the
procedure, practice on a few wire ends until you get it right.

hth
mike
86 5kcdtq
84 5ksw