RE: rear-window defroster-connection

[quinn@hns.com]

Phil Rose <pjrose@servtech.com> wrote:
>Well, while waiting for some qlist BTDTs regarding resoldering a detached
>electrical connector to the edge of the rear window [...] I'm inclined to
>give it a try myself in the near future [...] Will probably use silver
>solder, which I assume will require low(est) heat. [...] Any words of
>warning or encouragement?
Well I'm not sure I'd like to try this myself, but anyway, silver solder
normally has a HIGHER melting point than 'regular' solder.  Try to find
solder with a high lead to tin ratio for the lowest melting point.  Also
get a tin of flux (plumbing dept at your hardware store) and apply before
& during the process.

-Mark Quinn