Re: BTDT- clutch master & slave cylinder R&R

[Bob <mx@snet.net>]

Whitson wrote:

> Does anybody have any info that could assist me on doing this?
>
> Car: 1986 4000csq

Just did master on an 84. If it takes more than 5 minutes then something
wen violently wrong! :)

Two bolts from the engine bay on the firewall, detach the appropriate
hose(s) (Dont remember if there were one or two)
Remove the pin from clutch pedal from the inside. Reverse the order and
add fluid.
Bleed the slave while you're in there..(unless you are replacing it of
course).
You may have to remove the anitfreeze reservoir to access it..

Bob