Re: 90q Timing Belt Job q

[Richard J Lebens <rick-l@rocketmail.com>]

---Tony Lum <tlum@flash.net> wrote:
>
> At 11:48 AM 10/14/98 -0400, you wrote:
> >Tony,
> >
> >since you have just been there, I would like to ask you a couple of
things. 
> >1. I am unsure about the cam pulley alignment: the book says "the
top edge
> >of the gasket", 

Isn't a 90q a 20v and aren't you trying to line up the dot on the cam
pulley with the arrow cast in the valve cover?
_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com