Re: UrQ timing check.

[Martin Pajak <quattro@rogerswave.ca>]

ANDREW FINNEY wrote:

> Thanks Martin. The problem is that I was following the intro service procedures
> for verifying the non-"static" ignition timing. The timing varies with sensor
> input, like boost, etc. How does one check the timing if there are no marks or
> gradations, or are there?

The marks are there on the distributor (under the dust cover).This procedure is
only to set up the basic (according to guys at the dealership) timing.
>From there they verify the timing at different RPM using special tools.
If all components are working fine the basic setup should do the trick.
The other check while engine running will just tell you if there are any components
that are not functioning properly.

HTH

--
Martin Pajak

http://www.geocities.com/MotorCity/5939

1982 Audi Coupe Turbo (475,000 km) for sale
1982 Audi Coupe Quattro (155,000 km) Coupe with 4kq floor
1983 Audi Ur-quattro (220,000 km)
1986 Audi 4000 S Quattro (364,000 km) with 5 bolt pattern

C.E.O. of examlastminuteallnighterrollthedice inc.