Sunroof Switch LED broke.

["Steven Chan" <ykloveck@hotmail.com>]

Hi Kirby:
I finally opened the shell of switch and cut off the broken LED from the 
sunroof switch. There is a 2 ohm resistor attached with the LED. I am 
going to replace the LED later. Thank you very much for all your help. 
Very, very appreciated.
1) My next movement is fixing the LED flashing of the switches at the 
driver side armset. They are just keep flashing randomlly, do you think 
this is caused by the circuitry but the LEDs?
2) Do you know how to solve the problem about the sunroof such as 
sliding/flip-up movement?
3) My alarm is fine but it just doesn't "beep". Do you think it is the 
horn problem? Where is the horn/speaker for the alarm?

Any suggestion?
SC.
>I have found that one needs two items to open these swiches.  First, a
>jewelers screw driver with which to pry the shell near the pins, and 
second
>a set of shims (I use 0.010 nickel shim stock) cut to about 1/8 inch by 
1
>inch to block the internal plastic tangs from protruding into the outer
>shell.  It is also necessary to pry off the lever control so one can 
see the
>ends of the inner plastic assembly.  This is done by determining which 
side
>of the pivot is tapered and capable of being angulated out first.  Once 
the
>shims are in place, the inner assembly extensions below the lever are 
pushed
>upon to start the guts out of the rear of the switch.
>
>HTH
>
>kirby


______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com