[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: stock spring rates in an early 83 UrQ?

To: Martin Pajak <quattro@rogerswave.ca>
Subject: Re: stock spring rates in an early 83 UrQ?
From: Ken Keith <auditude@impulsedata.net>
Date: Sun, 20 Dec 1998 20:18:08 -0700
CC: Michael Williams <urquattro@surfree.com>, quattro list <quattro@coimbra.ans.net>
References: <199812210149.SAA05821@flamingo.impulsedata.net> <367DA948.BF46D998@impulsedata.net> <367D39F0.9298A165@rogerswave.ca>
Sender: owner-quattro@coimbra.ans.net

Martin Pajak wrote:
> 
> 
> > What do you have to do to the front?  Can't you just press the 5 bolt
> > hub there too?
> 
> No.  The bearing sizes are different.  Check my site for details.

Is the bearing size of the rear 5kt hub the same as a 4kq front?
Can you use four rear hubs, and press them into the 4kq's?

I don't know what would have to be done rotor-wise, tho'.

Is the bearing size of the 4kq the same front and rear?

Curious,

Ken
-- 
http://www.geocities.com/motorcity/garage/4153/

Follow-Ups:
- Hubs & bearings
  - From: "Bruce Bell" <bbell04@ibm.net>

References:
- Re: stock spring rates in an early 83 UrQ?
  - From: Ken Keith <auditude@impulsedata.net>
- Re: stock spring rates in an early 83 UrQ?
  - From: Martin Pajak <quattro@rogerswave.ca>

Prev by Author: re: 4kq Strut Lock
Next by Author: Re: FS: one 4k eurolite (passenger) lamp/frame/harness, drivers
Prev by thread: RE: stock spring rates in an early 83 UrQ?
Next by thread: Hubs & bearings
Index(es):
- Author
- Thread