RE: Wheels

["Bob Rossato" <bob.rossato@worldnet.att.net>]

> >P.S. I finally figured out that you measure diagonally from bolt center
> >to bolt center to get the bolt pattern. When I got the wheels I knew
> >they looked like 108's, but when I measured them after the purchase I
> >came up short since I was measuring adjacent holes. I was bummed out.
> >Recently I tried test fitting them to the 4k fwd which at this point I
> >had thought they should fit (100mm) and the holes were too far apart.
> >Hooray, that means they fit the Q.
>
> Thanks for the tip. I'd tried the same as you did before, and it came out
> wrong, too.
>
> Tom

Don't forget, this is fine for a 4 bolt pattern as the two holes will be
diametrically opposite, but for a 5 bolt pattern you'll have to measure from
the center of the wheel to the center of any bolt hole to get the radius,
then multiply by 2.

Bob R.