Re: blower motor.. getting close

["Doyt W. Echelberger" <Doyt@nwonline.net>]

Be sure that the old blower motor came out with it's black plastic cover
intact. You can't get the replacement into position if that old 3-legged
stiff plastic cover is still in there.

The motor only fits into it's cover one way, and the hole in the cover that
lets you see down into the brushes must be where the rubber ventilation
hose goes into the housing.

Doyt
>>>>>>>>>>>>>>>>>>>>>>>>>>
>At 12:26 PM 1/20/1999 -0500, you wrote:
>>Well, you guys have gotten me this far. I used the "break bottom screw"
method last night and
>>got the old blower out. Now, what is the trick (I hope there's one) in
getting the tab/slot  
>>to line up when you're installing the new blower. I tried for over an
hour with no luck. Can I break it 
>>off ? I wouldn't think the position of the blower in the housing would
make a difference, but I'll wait 
>>to hear back before I do anything....
>>
>>Thanks again,
>>
>>Bob Dunne
>>'90 200t 
>>
>>