Re: blower motor.. getting close

[MSV96@aol.com]

In a message dated 1/20/99 Robert Dunne <robert.f.dunne@mci.com> writes:

<< I used the "break bottom screw" method last night and
got the old blower out. Now, what is the trick (I hope there's one) in getting
the tab/slot to line up when you're installing the new blower. I tried for
over an hour with no luck. Can I break it off? I wouldn't think the position
of the blower in the housing would make a difference... >>

Use some silicone spray on the rubber housing of the motor and it will slide
right into place. The tab/slot is there to prevent the motor from rotating
when starting up so I wouldn't cut it. HTH

Mike Veglia
87 5kcstq