Wheel Bearing Tools

[Andrew Pawlisz <apawlisz@tufts.edu>]

I have found a site where one could buy such a tool.

http://216.42.24.52/toolstore/default.asp

It is about $300.

The problem is does it work? and How does it work?

Does one has to remove the strut to drive out the hub? In not, how does this simple tool remove the hub? Then, how does one use this tool to remove the inner race from the hub? or one has to purchase additional jaw puller? I can see the tool useful for removing the inner race and re-inserting the new bearing. What about reinserting the hub?

Apparently, one can do the job without removing the strut (an advantage if one does not want to risk upsetting the alignment, possible damage to the tie rod ends, and ball joints, not to mention extra "play" time). 

As I need to do my bearings, I look for options.  This tool might be one of them.  However, before I purchase it, I would like to know whether anyone has seen it in action?

Otherwise I am planning to remove the strut, take it to a shop to have them press the bearing, and $25 later reinstall the strut, followed by another $40 for alignment.  Total $65 plus a couple of beers and the cost of the bearing kit ($60).

Andrew Pawlisz
Boston, MA
84 4Ks
88 5KsQ