Re: Wheel Speed Sensor Grunge!

[FBFISH@aol.com]

In a message dated 2/4/99 12:40:59 PM Eastern Standard Time, dan@magnitude-
electronics.com writes:

<< Should I take them out clean them and tap them in with a mallet?  Am I
 still too far away?  should I skip the caps and just adjust them until
 they work properly? >>

Dan- I have a 1990 V8, but this technique ( which I have mentioned before) is
what my factory manual sez. "push the sensor in until it bottoms, and then
retract a small amount. Spin wheel to make sure its not rubbing." This worked
for me. I don't think the air gap is all that critical. The experts will as
usual correct this.
Frank Santoro
1990 V8 for sale
1998 A8