Re: 3 inch exhaust fabricators

["Tom Nestor" <tnestor@cyberportal.net>]

Doyt -
    It's tight but it does fit in the big cars. An acquaintance has
installed the TAP stainless system in his 92 S4 and it fits good with no
interference probs. It's seems, from the posts I've received on this
subject, that with some bush beating I should be able to find a competent
bender. Thanks
Tom



>Tom.....The pipe bender shop I use in Sandusky Ohio custom bends and fits a
>single system of aluminized pipe, a middle resonator and a rear muffler for
>under $200. Takes about an hour. Rainbow Muffler, corner of Perkins Ave and
>Milan Road. Lasts about 3 years in Ohio salt. Never did it in 3 inch pipe.
>
>The problem would be getting the 3 inch pipe over the rear axle. Not much
>clearance there on a quattro.
>
>Doyt Echelberger
>86 4kq
>87 5kcstq
>
>
>>>>>>>>>>>>>>>>>>>>>>>>>>
>At 06:25 PM 2/13/1999 PST, you wrote:
>>>    As the new motor now has about 2k miles on it, I'm looking for a 3
>>inch
>>>exhaust of aluminized steel. I just can't see spending the $2k on TAP's
>>>stainless scorpian unit. Is there anyone in the NE region doing this
>>
>>$2k! Youch! I built the dual system on my car... I'll send ya a Jpeg of
>>the underbelly should you want to check it out. Although I live in MA.
>>and have have access to the many of the tools, I don't have time to
>>build ya system. I'm more than willing to help ya get started in the
>>right direction though. The two systems that I've done in the past cost
>>from $300 - $700 (the present dual system). Both are stainless steel,
>>built from many pieces of pre-bent pipe...
>>
>>Brian
>>
>>______________________________________________________
>>Get Your Private, Free Email at http://www.hotmail.com
>>
>