Hall Sensor pick up pin bent (need quick answer)

[EICHSTEV@aol.com]

Jim said,

>  I just put the clutch in and noticed that one of the pick
>  up's for the hall sensor is bent slightly.  Must have bent it taking the
>  tranny out.  Should I try to strightten it or is it ok to be slightly bent

If you are talking about the long pins that stick out the back side, they
aren't even used.  These are only for the factory test equipment.  The pin
that is used is on the front side of the flywheel and is much shorter.

Straighten it if you wish, but I wouldn't worry about it as long as it doesn't
interfere with the bell housing, pressure plate, etc..

HTH!

Steve Eiche