Bypass valve Installation?

[Tony Lum <tlum@flash.net>]

Hi gang,

I was scoping out a junked BAAS 9000 16V turbo yesterday and can absolutely
state that the right angle connection was attached to the turbo inlet and
the in-line (with the vacuum control) connection was attached to the
pressure side at the output of the inter cooler.  I though it was supposed
to be just the opposite!

What gives, or does the orientation really matter?

P.S. I would have taken most of the turbo plumbing, but the diameter was
quite a bit smaller than the metal KH turbo elbow pipe I took off another car.

Regards,

-Tony
_______________________________________________________________________

Tony Lum                                  1987 5000CS Turbo Quattro
Berkeley, California, U.S.A.                1985 4000CS Quattro
Audi Owner/Driver/Mechanic by Necessity ;^)   1980 5000S Sedan
QCUSA Member #6885                            1987.5 Coupe GT
_______________________________________________________________________