[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: urq vacuum hose lengths - new info



On Tue, 23 Feb 1999, Phil Payne wrote:

]In message <001801be5efe$2315fbe0$4d160d0a@powks15> "Jouko Haapanen" writes:
]
]>> From my recent experience, I'd say around 1.2km should suffice...  ;^)
]
]> Sorry, just one of those moods.
]
]Even more on a WR/WX.  There are five lines to the differential lock
]switch - at least on the MB you only have the engine compartment
]and the rear differential controller to actuator links.
]
]Actually, it's a stupidly easy question to answer.  From EKTA AQS
]83/7/11/58-10:
]
]N 020 353 5     1 x 810mm
] (fabric        2 x 245mm
]  covered       7 x 100mm
]  rubber)       4 x 45mm

	i'm not sure if you knew i was only looking for the
	hose for the engine compartment.  anyway, i spoke to 
	rod at tpc (with that voice he should be a dj) and 
	this part number (N 020 353 5) is nearly identical 
	hose - diameter and all that - but has a yellow
	stripe and is "diesel injector" hose.  he said it
	would probably work the same, but that according to
	his info, the vacuum hose for the ur-q is actually
	N 020 3532.

	also, there will shortly be a special on urg front
	strut bearings.  $20 each, as opposed to $140 from
	the dealer.  he told me to pass that on.  hey mike,
	do i need these? ;)


--
 rocky mullin
 http://caliban.sf.ca.us/
 two strokes are faster than four!
 this message was composed using the vi editor.
 '83 ur-q - yamaha rz350 - suzuki ts250 -  chaotic good