Re: Need part numbers

[Dwight Varnes <mxbreed@lancnews.infi.net>]

Greg Herrmann wrote:
> 
> I am trying my first attempt at auto upholstery and I need the part numbers
> for the molded foam rubber for the front seats on my 86 CGT.  I would like
> to be able to use the molded stuff as opposed to trying to cut new foam to
> fit.  I took off the seat covers yesterday (leather) and stitching them up
> looks simple.  Any help from you guys with the fiche would be GREATLY
> appreciated. 

Greg, 
I would check these numbers for accuracy before ordering, as they may
have been superceded since my fiche was printed, OR I may have made an
error as the seat pages are a bit complicated. BUT...I'm pretty certain
I did right by you. The foam is 'unisex', meaning it doesn't care which
seat it's for.

Backrest P/N 811-881-775A
Bottom P/N   855-881-361C

Good luck!

-- 
"Life is too short to drive boring cars."

Dwight Varnes, insurance appraiser and car nut
1970 124 Spider (restored, mostly)
1986 Audi Coupe GT (bigger engine at machine shop)
1989 VW Jetta GLI 16v (the wife's ride, needs restored)
1984 Nissan 4x4 Pickup (rust never sleeps)
1965 Buick Skylark conv. (more fun than you'd think)