sychronized

[Mike Mulholland <meyeke@netinc.ca>]

i had the similar rhythmic rumble and resolved it by regreasing the cv's. to
do the without a major repair, i made up a 10" length of 1/8" brake line. to
this i brazed on a zerk fitting on one end. i then flattened the other end
and rounded the sharp corners. filled my grease gun with cv grease and
pumped ~ 20 shots into each joint from the small side of the boot. on the
outers the clamp must be removed. i replaced it with a standard stainless
hose clamp. if the boot is really old but in good shape it may be stuck
quite tightly to the shaft. a long narrow common screwdriver with a rounded
tip can be wiggled under the stuck boot and the grease tool slid in
alongside it.
hth 
mike
86 5kcdtq, tap chip sjm spring
84 5ks
84 5ksw
many cyclops bicycles