[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Consistently Warped Rotors Driving Me Nuts



Richard -

I totally agree! On my 87 5Kcstq (IA stage 1) I went thru 2 sets of
rotors that warped - and this was before I chipped up the HP. Then I
bought

	 **cross-drilled rotors**

 from Group 6 performance somewhere in AZ (they're a European Car
advertiser) and the problem 'magically' went away.

No change in my driving habits, No Big Brakes set up needed, & I don't
buy that two different shops improperly torqued the first two sets of
rotors. Just cross drilled rotors. I believe slotted would work too.

I got lots of miles out of them (4+ years).

Now I've put on ATE PowerDiscs rotors with Ferodo pads. Again no
warping so far (about 9 months - plenty of time if the original
problem were to re-occur).

YMMV - Mark



On Wed, 19 May 1999 09:08:26 -0400, you wrote:

>
>I've had an issue with the brakes in my 5KCSTQ for some time.  I go to Audi
>(dealer) and have the front rotors replaced on a 6-month (or so) rotation
>(for free) due to the fact that they keep warping.
>
>Why does this keep happening?  Is it the caliper? pads?
>If none of the above, then should I convert to drilled or slotted rotors?
>If so, who makes a good set?  I saw a set at TAP, but they're steep
>($2200). then again,  everything is included..
>
>TIA for as many of your thoughts and comments as possible.
>
>Regards,
>
>Richard
>

Mark Aaldering
Mark.Aaldering@ieee.org