[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: O2 sensor question 4kq CIS-E



In a message dated 5/26/99 12:20:34 AM Central Daylight Time, IraT@aol.com 
writes:

<< I have heard of purchasing a non Bosch O2 sensor (3 wire) without the 
 electrical connection.  But cut and splice using the old connector wit the 
 new sensor.  Is this possible?  Would any other O2 sensor fit my 
application? 
  Any other recommendations would be greatly appreciated.  Thanks.
 Ira T >>
	A Bosch three wire sensor is a Bosch three wire sensor. The only 
difference is the plug on the end. The wires can be cut and spliced, but make 
sure you do a good job splicing, otherwise the engine will go nuts if the 
splice gets loose. (Personal experience does wonders for the Audi  
education.) As I recall from recent list comments, crimping is in -- solder 
is out.

	After while.
	TBD