Re: 87 5kcsq Clutch replaced, now car wont start

[BLEVINSBK@aol.com]

		They may have broken the reference pin off of the flywheel. 
Did the remove/refinish the flywheel? They can either check for the pin by 
sight (coming out of rear of flywheel,engine side).They can also check for 
the sine wave from both crankshaft sensors(reference and position). It takes 
a scope, and I believe you hookup to pins 1 and 2 of the sensors. You should 
see a 1 to 2 volts wave.           					Good 
luck