RE: wheel bearings on a 4kq

[Thomas Barbera <tjbst39+@pitt.edu>]

	Where can I get this tool and for how much???  It sure would've saved me a lot of time.
	Thanks in advance for the advice.

Tom B.
'86 4kq
'89 200q


-----Original Message-----
From:	----> Bob [SMTP:mx@snet.net]
Sent:	Tuesday, June 29, 1999 10:23 AM
To:	Thomas Barbera
Cc:	'quattro@audifans.com'; 'meyer@netconx.net'
Subject:	Re: wheel bearings on a 4kq



Thomas Barbera wrote:
> 
>         The strut housings will have to be removed to replace the wheel bearings.
>  I would recommend taking the housings off and taking them to a shop to be
> pressed out.  They can also press the new bearings in.  When I replaced the
> bearings on my 4kq,

There is a tool that will remove/install the new bearing in the car. It
makes a sucky job REAL easy.  Id ask if you could borrow or rent the
tool before going through all that!

Bob