Re: ur-q wont crank

[FBFISH@aol.com]

In a message dated 7/26/99 9:45:43 PM Eastern Daylight Time, 
audi@mediaone.net writes:

<< the neg "terminal" is the starter mounting bolts isn't it?
  >>
Huw- I have no experience with this starter/solenoid, but if the ground for 
the solenoid is through the frame/mounting, one could perform a resistance 
check of the solenoid coil. Just disconect the pos lead to the solenoid, and 
read ohms to ground. Some other thoughts to help the lad trouble shoot. 
Applying (jumper cable gauge wire) 12 volts to the starter side of the 
solenoid will bypass the solenoid contacts, but must be done with care. Not 
only will there be a large current draw, but the engine may start (watch 
those fingers!!). If the starter has a dead spot even this will not get the 
engine  to turn but you will know  the starter needs rebuild/replace. HTH