Re: 200TQ visor removal?

[Larry Mittell <lmittel@ibm.net>]

The visor mounting screws on your 200 are hidden by a plastic cap snapped over
the mounting flange. Some careful prying with a small flat-bladed screwdriver
should persuade it to come off without damage. I don't remember if the 5k visor
mounting flange will accept the cap or not. I suspect not. OTOH, you could do
as Frank Martin suggests: simply pull the old visor off its rod and push the
replacement on in its place. The latter method has the virtue of being very
easy to try. If it doesn't work you can always revert to Plan A.

Larry Mittell

At 02:32 PM 09/09/1999 , you wrote:
>How do you remove a visor from a 1989 200TQ?
>
>I pulled a nice (not drooping) visor out of a 5KTQ at a great junkyard
>(Bry's) in Seattle.  It just had two screws.  Then I look at mine and it's
>identical except it has no visible screws.  How is it held in place and how
>do I remove it?  I just figured I'd ask before I begin to pry and break
>something.