[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 5kt/4kq Driveshaft Differences???

To: Todd Phenneger <phen9461@uidaho.edu>
Subject: Re: 5kt/4kq Driveshaft Differences???
From: Martin Pajak <urquattro@wave.home.com>
Date: Mon, 13 Sep 1999 19:38:20 -0700
CC: quattro list <quattro@audifans.com>
References: <Pine.GHP.4.05.9909131605500.24772-100000@raptor.csrv.uidaho.edu>
Sender: owner-quattro@audifans.com



Todd,

> Can I use either a 5kt Axle or a 5kt outer CV joint on the 4kq front axle???

That was my other option if I was not able to find rear 4kq axles (lucky I did
though).
I never tried it either but would love to know if it works.
The rear 4kq axles are a bit longer than the front 4kq axles respectively.
If the front 5kt outer CV joint is a bit longer than the front 4kq outer CV
joint and fits the shaft splines I don't see any problems.

HTH
--
Martin Pajak

http://www.geocities.com/MotorCity/5939

1983 Audi Ur-quattro (225,000 km)
1986 Audi 4000 S Quattro (410,000 km) with 5 bolt pattern

Follow-Ups:
- Re: 5kt/4kq Driveshaft Differences???
  - From: Todd Phenneger <phen9461@uidaho.edu>

References:
- 5kt/4kq Driveshaft Differences???
  - From: Todd Phenneger <phen9461@uidaho.edu>

Prev by Date: Re: Q's FS on TraderOnline
Next by Date: Re: Where is my idle switch?
Prev by thread: 5kt/4kq Driveshaft Differences???
Next by thread: Re: 5kt/4kq Driveshaft Differences???
Index(es):
- Date
- Thread