Re: Speaker wiring question

[Cynic5KS@aol.com]

In a message dated 10/28/99 10:31:53 PM Eastern Daylight Time, 
ewendell@iolinc.net writes:

>   Consider yourself lucky. I'm in the process of rewiring my whole system
>  due to the fact that the previous owner (ie amateur monkey lad) cut off
>  all the original head unit connectors, dispensed with the crossover, cut
>  out all the door wiring, and did a twist and electrical tape job on the
>  crappy wire he ran to the 6" door speaker. I'm planning on using two of
>  my head outputs to run the dash speakers and using the other two to
>  power a two way setup in the doors. I'm hoping to use my preamp outputs
>  to run the stock rear amp, but I've yet to decode the wiring to it even
>  with the help of the Bentley.
>  
>  Hope that was the answer you were looking for. Let us know how it goes.
>  
>  Roy Wendell
>  86 5kcstq
>  Clarksburg WV, USA
>  

Roy, 

You are probably better off rewiring your system...  Stock wiring is usually 
too small of a guage to handle the higher power ratings associated 
amplifiers.  

Arden